OPAL Plus

 برای درک بهتر لطفا بروی مقاله کلیک کنید و مقاله فارسی را مطالعه کنید

OUTDOOR PIR + MW DUAL TECHNOLOGY MOTION DETECTOR

The OPAL Plus is an outdoor dual technology motion detector, which

is perfectly suited for application both on the outside of the protected

building as well as indoors, where difficult or specific environmental

conditions prevail (in halls, under umbrella roofs, etc.). The

OPAL Plus detector incorporates PIR and MW technologies, as well

as antimasking function based on the microwave technology. The

dual technology combined with the algorithm of detector auto–tuning

to the environmental conditions ensures high immunity to false alarms

and, consequently, stable operation in harsh weather conditions,

such as rain, snow, sunshine and strong gusts of air. The device

offers correct operation in a wide temperature range from –40°C to

+55°C, the ambient temperature changes being

automatically compensated.

The OPAL Plus detector has a detection angle as wide as

100 degrees and a reach of more than 15 meters. Also, as the look

down zone is protected, any intruder's attempt to approach the device

to damage it or pull it off will be detected. In addition, the detector

software has been designed so as to avoid false alarms caused by

the movement of small pets. The OPAL Plus detector is also provided

with a dusk sensor for OC output control, which allows it to be used in

alarm systems with home automation, without having to install

additional dusk detectors. The signal from the low–current output can

be passed directly to the relay located in the electrical switchboard or

to the home automation controller. The detector can also interface

with the KNX system via a control panel of the INTEGRA series.

Thus, the OPAL Plus functionality allows you to easily and

conveniently control, for example, the roller shutters, building exterior

lighting, garage door or entrance gate, as well as select the moment

of operation through fine sensitivity adjustment. A big help for the

installer is the function of remotely changing sensitivity of all detection

circuits and dusk sensor with the OPT–1 keyfob, which eliminates the

need for repeatedly opening the detector enclosure to change the settings.

Also the device enclosure is unique, as it is made using two–component injection molding technology. The result of it is a splash–proof IP54 rated design, which

protects the OPAL Plus electronics against harmful atmospheric phenomena. The detector enclosure is also characterized by high mechanical strength and

resistance to UV radiation. For additional protection of the device against atmospheric precipitation and fouling, you can install the HOOD C (white) or HOOD C

GY (gray) protective cover on the detector enclosure.

The OPAL Plus detector is designed for mounting directly on a flat surface. If the detector is to be turned vertically or tilted horizontally, you can use special

angle–type or ball–joint type brackets from the BRACKET C set (white) or BRACKET C GY set (gray).

The OPAL Plus detector is available in two color versions: white (OPAL Plus) and gray (OPAL Plus GY).

dual technology: PIR and microwave

anti–masking function based on the microwave technology

built–in dusk sensor which allows the detector to be used in automation systems

configuration of the sensitivity of detection paths and dusk sensor using the PCB buttons

built–in receiver of the OPT–1 IR keyfob signal

remote configuration of the sensitivity of detection paths and dusk sensor with the OPT–1 keyfob without having to open the detector enclosure

splash–proof polycarbonate enclosure, IP54 rated

tamper protection against opening and detachment

digital temperature compensation for correct detector operation in –40°C to +55°C temperature range

can be used in adverse weather conditions (rain, snow, fog, strong wind)

high immunity to false alarms because of the use of auto–tuning algorithm

small animal immunity option (up to 20 kg)

low power consumption

can be installed directly on a flat surface or with the use of dedicated brackets from BRACKET C set:

angle type bracket: constant 45° angle

ball–joint bracket: adjustable vertically through 60° and horizontally through 90°look down creep zone control 

از مقاله مربوط به این دتکتور در بخش مقالات بازدید کنید

از فیلم  مربوط به این دتکتور در بخش فیلم های آپارات بازدید کنید

قیمت : تماس